Setting Maximum Time In Use - Artweger Body+Soul Utilisation Et Entretien

Programming maximum time in use /
Programming the remote control
Programming maximum time in use
The Body+Soul has an integrated, automatic cut off. When the
steam generator is started, a counter begins to count down.
When the pre-determined maximum time in use has been reached
the steam generator turns off automatically.
Instruction: To set the maximum time in use the steam ge-
nerator has to be turned off; the blue ring around the ON/
OFF key may not shine or blink.

Setting maximum time in use

• First press and hold the (+) key, then in addition press and hold
the ON/OFF key. Hold both keys together for at least 2 seconds.
• The blue ring around the ON/OFF key begins to blink rapidly
(flicker).
• Use the +/– keys to set the maximum time in use according to
the following table.
• If no key is pressed for approximately 5 seconds the values
displayed are saved.
• All LEDs go off and the setting process is finished.
Check the current setting
• First press and hold the (+) key, then in addition press and hold
the ON/OFF key. Hold both keys together for at least 2 seconds.
• The blue ring around the ON/OFF key begins to blink rapidly
(flicker).
Programming the remote control
The remote control has already been set for your Body+Soul at the factory. In case there is any need to
re-program it please follow these steps:
• Disconnect your BODY+SOUL from the power source. Turn off the electricity.
• The remote control has to be turned off for at least 10 seconds. (No LED is lit!)
• On the Audio side of the remote first of all press and hold the (-) and (+) buttons, in addition press the EIN/AUS button once.
• The colored EIN ring begins to blink rapidly.
• Reconnect the BODY+SOUL to the power source (within 5 minutes). Turn the electricity on again.
• The LEDs 1-7 light up for 1 second if the programming has been successful.
• The colored ring goes out.
• The remote control is programmed.
• The EIN/AUS button stops the programming process.
RADIO/AUX
• Press the Ein/Aus button on the audio side of the remote
• Press the select button twice = switch from radio to AUX or from AUX to radio,
(the LED for RADIO or AUX lights up). When selecting an external device please connect it to the roof element provided.
• If two external devices are connected to the roof element (an AUX signal by way of a 3.5 mm stereo jack and socket and
an MP3 signal with a USB Type A) the MP3 signal has preference.
• With the -/+ button select the desired station/music track. In radio mode the LEDs show the current station.
• The current setting is shown on the LEDs 1 to 7.
• Do not press any other keys. The control returns to its original
status after approximately 5 seconds.
Return to default settings
• First press and hold the (+) key, then in addition press and hold
the (–) key and in addition press and hold the ON/OFF key. Hold
Display
all 3 keys together for approximately 2 seconds.
• The maximum time in use setting returns to the default setting.
20
maximum time in use
30 minutes
40 minutes
50 minutes
60 minutes (default setting)
70 minutes
80 minutes
90 minutes