Operation Of Colored Lights System - Artweger Body+Soul Utilisation Et Entretien

Colored Lighting
Select key for
• Color
• Color intensity
COLOR
• Press the ON/OFF key to start the colored lighting.
The Color LED shines as well as LED 1 (= first pre-programmed colored lighting
begins to shine).
• Select the desired color with the +/– key. 7 colors are pre-programmed.
• By pressing and holding the +/– key you can individually set mid-tones.
INTENSITY
• Press the Select key for color intensity (LED INTENS shines).
• Select the desired intensity with the +/– key. The LEDs show the current intensity.
Automatic color cycle
• Press the EIN/AUS button, the Color LED lights up.
• First, press and hold the (–) button then in addition tap the (+) button.
• The active function is shown by a light running through the LEDs 1-7.
• The color cycle is ended by pressing and holding the (–) button again and in addition tapping the (+) button.
Setting and saving of individual colors
• The remote control has to be turned off for at least 10 secs. (No LED is lit!)
• First, press the (+) button and in addition the EIN button.
• Color LED lights up and the ring EIN blinks.
• Select the color with the -/+ button (tap or press and hold).
• To save a color, press the select button.
• Select the place to save the color with -/+ button.
• Confirm with the select button. The color is saved.
• It is possible to save 7 colors.
• If no button at all is pressed for approx. 15 sec. the save mode ends. The colored ring EIN goes out.
Return to factory settings
• The remote control has to be turned off for at least 10 secs. (No LED is lit!)
• First press and hold the (–) button and press and hold the (+) button AND in addition press and hold the EIN/AUS
button for at least 2 seconds.
• The blue ring lights up for approx. 1 second, the colors return to the factory settings.
Operation of Colored Lighting
On/Off
(When ON the outer
ring shines blue)
LED for
• Color mode
• Color intensity mode
E L E M E N T S O F B A L A N C E
LED for
• Color
• Color intensity
–/+ key for
• Color selection
• Intensity setting
17
EN