Unit Description; Initial Use - Beurer MP 50 Mode D'emploi

3. Unit description

1. Base device
2. Base station
3. Coarse callus attachment
4. Fine callus attachment
5. Unlock button
6. Fixing cap
7. LED light
8. Battery level indicator
9. On/off switch with 2 speed settings
10. Protective cap
11. Protective cap for skin cells

4. Initial use

• Remove the packaging.
• Check the device, mains plug and cable for damage.
• Connect the device to the mains. When doing so, the device must be switched off.
• Ensure that the cable does not pose a trip hazard.
• Charge the device for 2 hours before the first use. If the battery level indicator flashes
slowly this means that the battery is charging. Once the display is permanently
illuminated, the device is fully charged. Then you can begin using the device either on
battery power or using the mains cable.
• If the battery level indicator flashes rapidly during battery operation, the battery is empty.
Charge the device by placing it on the charger or connecting it to the mains adapter.
• One charge is sufficient for approx. 30 minutes of cordless operation. After that you can
continue to use the device via mains operation.
IMPORTANT
• For hygiene reasons, you should not share the attachments with anyone else.
• When switched on, the device should not come into contact with other areas of
skin (e.g. eyelashes, head hair, etc.), or with clothes or cords, to avoid injury as well
as blockages or damage to the device.
• Do not use the device on irritated skin, varicose veins, rashes, spots, (hairy)
birthmarks or wounds without consulting a doctor beforehand. The same applies
to patients with weakened immune systems, diabetes, haemophilia and immune
insufficiency.
3
1
9
5
13
6
6
8
6
2
10
7
11
4
3