Worx Jawsaw WG307E Notice Originale page 19

• Follow steps outlined in this manual to
sharpen Saw Chain.
• Keep handles clean and free from oil.
• Keep all screws and nuts tight.
• Never carry the JawSaw by the Power
Cord.
• Never yank the power cord to unplug it.
• Keep power cord away from heat, oil
and sharp edges.
• Inspect extension cords and do not use
if damaged.
5. When servicing, use only identical
replacement parts.
6. When not in use, always store JawSaw
• In a high or locked place, out of
children's reach.
• In a dry place.
rEPLACINg SAw CHAIN/CHAIN BAr
Replace the Saw Chain when cutters are too
worn to sharpen or when chain breaks. Only
use replacement chain noted in this manual.
Always include new drive Sprocket (16) when
replacing the Saw Chain. This will maintain
proper driving of chain. Inspect Guide Bar
(10) before sharpening chain. A worn or
damaged guide bar is unsafe. A worn or
damaged Guide Bar is unsafe, will damage
the Saw Chain, and will make cutting harder.
For Replacing the Guide Bar please refer to
CHANgINg THE guIDE BAr AND CHAIN
section in the Adjustment and Assembly
Instructions.
SHArPENINg SAw CHAIN
wArNINg:
unplug JawSaw from power source
•
before servicing. Severe injury or
death could occur from electrical
shock or body contact with moving
chain.
Cutting edges on chain are sharp.
•
use protective gloves when handling
chain.
Keep Saw Chain sharp. Your saw will cut
faster and more safely. A dull Saw Chain will
cause undue Sprocket (16), Guide Bar (10),
Saw Chain, and motor wear. If you must
force the Saw Chain into wood and cutting
creates only sawdust with few large chips,
then the Saw Chain is dull.
Limbing and Trimming Electric Chain Saw En
LuBrICATINg THE CHAINwHEEL
NOTE: It is not necessary to remove the
chain or bar when lubricating the chainwheel.
1. Clean the Guide Bar and chainwheel.
2. Using a grease gun, insert the tip of the
gun into the lubrication hole (h) and inject
grease until it appears at the outside edge
of the chainwheel sprocket tip (See Fig.
AD).
3. You may need to rotate the chainwheel (i)
in order to grease all areas of the wheel.
To do this, pull the Saw Chain by hand to
rotate the chainwheel and align the parts
of the wheel that needs to be greased with
the lubrication hole (See Fig. AD).
CLEANINg
Regularly open the Chain Access Cover (12)
and remove any debris that has become
trapped.
Regularly clean the ventilation slots with a
clean, dry paint brush.
To clean the tool, use only mild soap and a
damp cloth. Never let any liquid get inside
the tool and never immerse any part of the
tool into liquid.
TrANSPOrTINg
Always transport the tool with the Guide Bar
(10) and Saw Chain (11) inside the protection
guard.
19