Worx Jawsaw WG307E Notice Originale page 14

7. Before re-fitting the Guide Bar, check that
the small oil hole (b) and chain slot (c) are
not blocked by dirt or sawdust, use a small
toothpick to clean if necessary (See Fig.
G1, G2).
8. Refit the Saw Chain to the Guide Bar. Note
the correct direction of the teeth (See Fig.
H). The cutting direction is inward on the
lower cutting edge.
9. With the mounting plate (a) side of
the Guide Bar facing the Motor (8) and
holding the Saw Chain in place on the bar,
feed bar and chain into the jaw, angling
over the bar locating pins (d) and pulling
the Saw Chain over the drive Sprocket (16)
(See Fig. I). There will be is little excess
Saw Chain length, therefore, the Saw
Chain must be properly fitted in the Guide
Bar slot to provide enough extra chain to
be pulled over the drive Sprocket.
10. Check if all parts are seated properly
(See Fig. J).
11. Refit and tighten the Chain Tensioning
Bolt. Note the cam (e) of the Chain
Tensioning Bolt will engage the projecting
tab (f) of the bar mounting plate and push
the bar outward to tension the chain,
check for correct tension (See Adjusting
14
the chain tension).
12. Close the Chain Access Cover and remove
the Lock Pin.
LUBRICATIOn
IMPOrTANT: The JawSaw is
shipped with an empty oil tank. It
is essential to fill with chain oil before
use. Bar and chain oil of any brand can
be used.
Never operate the JawSaw without
chain oil or an empty tank as this will
result in poor cutting performance,
motor overload and possible burn-out.
FILLINg OIL TANk:
uNPLug THE TOOL BEFOrE FILLINg
wITH OIL.
1. Fill Oil Bottle (19) with chain and bar oil
(See Fig. K).
2. Rest the JawSaw with the Oil Filler (6)
facing upward.
Limbing and Trimming Electric Chain Saw En
3. Uncrew the oil filler cap (g) open.
4. Use bottle to fill oil reservoir (See Fig. L).
5. Screw the oil filler cap (See Fig. M).
IMPOrTANT: use only the
recommended oil to avoid damage
to the JawSaw. Never use recycled/old
oil. use of non approved oil will
invalidate the warranty.
CHECkINg THE AuTOMATIC OILEr
The JawSaw uses a much lower chain speed
than a conventional chainsaw so it needs
much less oil.
However it is very important that it always
has oil.
Check the Oil Level Window (5) and refill as
necessary.
During operation, periodically check the
Saw Chain (11) and Guide Bar (10). A slight
oil presence should be visible. If the chain
and bar appear completely dry, then remove
the bar and chain (see previous section) to
ensure the bar oil hole is not blocked.
If the oil hole is clear, there is oil in the tank
and still no oiling of the chain is visible –
contact Worx customer service.
wArNINg: Do not push the rear
handle repeatedly when the saw is not
cutting. The oil will be bumped out when
pushing the handle whether the motor runs
or not.
OPERATIOn
Prepare your JawSaw for use
wArNINg!
• Read and understand all instructions.
Failure to follow all instructions listed
may result in electric shock, fire and/
or serious personal injury.
• Sharp moving blade. To prevent
accidental operation, ensure that
the tool is disconnected from the
power source before performing the
following operations, failure to do this
could result in serious personal injury.
CAuTION: Sharp moving blade.
Always wear protective gloves