Worx Jawsaw WG307E Notice Originale page 17

the ground should be cut from the bottom up
to avoid binding the JawSaw.
BuCkINg A LOg (See Fig. x)
Bucking is cutting a log into lengths. It is
important to make sure your footing is firm
and your weight is evenly distributed on both
feet. Follow the simple directions for easy
cutting.
wArNINg: (See Fig. y)
• If on slope, make sure log will not roll
down hill. Secure log by using
wooden stakes. Drive wooden stakes into
ground on downhill side of log. Stand on
uphill side of log while cutting. Log may
roll after cutting (See Fig. Y).
• Never try cutting through two logs at
same time. This could increase the risk of
kickback.
• While cutting log, never hold log with your
hand or leg.
• While cutting log, never allow another
person to hold log.
• Turn off and unplug saw before moving
from one place to another.
ASSEMBLInG THE
EXTEnSIOn POLE (WHEn
USED WITH OPTIOnAL
POLE ATTACHMEnT)
wArNINg: Before attaching the
Extension Pole (20), make sure
that the tool is switched off and
unplugged.
1. Turn the release lever to allow the handle
clamp to spring open (See Fig. Z1).
2. With the Extension Pole slightly angled
away from the tool, insert the steel tab
into the slot (I) behind the Front Handle(7),
then swing the pole towards the tool's
Rear Handle(3) (See Fig. Z2).
3. Position the Extension Pole handle clamp
inside the JawSaw's Rear Handle as
shown in Fig Z3. To allow the clamp to
properly fit the handle, push the lock out
button and depress the trigger.
Limbing and Trimming Electric Chain Saw En
4. Close the clamp, the locking lever will
automatically lock into place.
5. Check that the rear handle is properly
fitted to the clamp and check that the
clamp is properly set in the lock position.
6. Plug in the tools power cord to the
Extension Pole power cord
Z4).
wArNINg:
• Before attaching the power cord of
the machine to the power cord of the
Extension Pole (
sure that the tool is switched off and
unplugged from the power supply.
• When using this machine with the
Extension Pole, make sure that
attaching the power cord of the
machine to the power cord of the
extension pole, and then attach the
power cord of the extension pole to
power supply.
ELECTrOCuTION HAZArD
Never use the JawSaw or Extension
Pole in an area with overhead power
lines or where the branch being cut can
come into contact with overhead power
lines.
CuTTINg wITH SHOuLDEr STrAP
(wHEN uSED wITH OPTIONAL POLE
ATTACHMENT) (See Fig. Z5)
The Extension Pole is supplied with a
shoulder strap that gives extra support when
hoisting the Jaw Saw in the air. Hook the
shoulder strap to the Extension Pole and
wrap around your shoulder. The shoulder
strap can also soften the impact if the
JawSaw is dropped after the completion of
a cut.
CuTTINg wITH ExTENSION POLE
(wHEN uSED wITH OPTIONAL POLE
ATTACHMENT)
1. Attached the Extension Pole as described
in ''ASSEMBLINg THE ExTENSION
POLE''.
2. Connect the JawSaw to extension cord.
Connect extension cord to power supply.
NOTE: The JawSaw is quite heavy on the
(See Fig.
in Fig. Z4), make
17