GE GFWN1100 Guide De L'utilisateur Et Instructions D'installation page 8

About the washer features.
NOTE: Features may not be available on all washer models.
Remove for powder detergent
Max HE
Liquid
Detergent
Setting
For Liquid
Detergent
Remove For Powder
2X HE Liquid
Max Fill
Detergent Setting
2X Fill
(most common
3X Fill
setting)
3X HE
Liquid
Detergent
Setting
Appearance may vary
Remove for powder detergent
Normal
HE Liquid
Detergent
remove for powder
Setting
2X HE Liquid
Detergent Setting
(most common
setting)
DETERGENT
3X HE
Liquid
Detergent
Setting
Appearance may vary
8
The Dispenser Drawer
Slowly open the dispenser drawer by pulling
it out until it stops.
After adding laundry products, slowly close
the dispenser drawer. Closing the drawer too
quickly could result in early dispensing of the
bleach, fabric softener or detergent.
The Prewash Compartment
Only use the Prewash Compartment if
you are selecting the Prewash cycle for
heavily soiled clothes. Add measured
detergent or prewash additive to the
back left prewash compartment of the
dispenser drawer.
Detergent or prewash additive is flushed
from the dispenser in the prewash cycle
(if selected).
The Detergent Compartment
High-efficiency detergent is required
for this washer. Use the detergent
manufacturer's recommended amount.
Add measured detergent to the front left
detergent compartment of the dispenser
drawer.
Detergent is flushed from the dispenser
at the beginning of the wash cycle. Either
powdered or liquid detergent can be used.
On models with a removable detergent cup
Powder Detergent – Remove the
liquid detergent cup and place it in a
safe location outside of the washer.
Follow the detergent manufacturer's
instructions when measuring the
amount of powder to use.
On models with a selection insert
The detergent selection insert must be placed
in the detergent compartment in a specific
position according to what type of detergent
you are using.
Powder Detergent – Remove the
detergent selection insert and place it in
a safe location outside of the washer.
Liquid Detergent – You will need to adjust
SO
the insert according to the type of Liquid
Detergent you are using. The Icons on the
side of the detergent compartment must
line up on the center when the insert is in
position.
You may see water in the bleach and fabric
softener compartments at the end of the cycle.
This is a result of the flushing/siphoning action
and is part of the normal operation of the
washer.
(on some models)
NOTE: Liquid detergent will drain into the
washer drum as it is added.
Detergent usage may need to be adjusted
for water temperature, water hardness, size
and soil level of the load. Avoid using too
much detergent in your washer as it can
lead to over sudsing and detergent residue
being left on the clothes.
Detergent usage may need to be adjusted
for water temperature, water hardness,
size and soil level of the load. Avoid using too
much detergent in your washer as it can lead
to oversudsing and detergent residue being
left on the clothes.
Using more detergent than the
recommended quantity can cause residue
buildup on your washer.
Liquid Detergent – Locate the
concentration of your detergent on the
bottle. Do not fill above the Max Fill line
in the detergent cup for your detergent
concentration type.
NOTE: Not all models have the 2x and 3x
detergent settings. Some have only regular
HE detergent settings. You must reduce the
amount of detergent for 2x or 3x detergent
per bottle instructions.
Move the insert by pulling it up and replace
it by sliding it down between either the rear
or front detergent compartment molded
rails, as desired, for liquid detergent.
Remove for powder detergent.