Installing The Washer - GE GFWN1100 Guide De L'utilisateur Et Instructions D'installation

INSTALLING THE WASHER

1. Run some water from the hot and cold faucets to flush
the water lines and remove particles that might clog up
the inlet hoses and water valve screens.
2. Obtain inlet hoses locally.
3. Ensure there is a rubber
washer in the hoses. Reinstall
the rubber washer into the
hose fitting if it has fallen out
during shipment. Carefully
connect an inlet hose to
the outside "H" outlet of the
water valve. Tighten by hand,
then tighten another 2/3 turn
with pliers. Carefully connect
the other inlet hose to the inside "C" outlet of the water
valve. Tighten by hand; then tighten another 2/3 turn
with pliers. Do not crossthread or over-tighten these
connections.
4. Install the screen washers by inserting them into the free
ends of the inlet hoses with protruded side facing the
faucet.
H
Inlet Hose
5. Connect the inlet hose ends to the HOT and COLD water
faucets tightly by hand, then tighten another 2/3 turn
with pliers. Turn the water on and check for leaks.
Installation Instructions
C
Screen
Washers
6. Carefully move the washer to its final location. Gently
rock the washer into position ensuring inlet hoses do
not become kinked. It is important not to damage the
rubber leveling legs when moving your washer to its final
location. Damaged legs can increase washer vibration. It
may be helpful to spray window cleaner on the floor to
help move your washer into its final position. NOTE: To
reduce vibration, ensure that all four rubber leveling legs
are firmly touching the floor. Push and pull on the back
right and then back left of your washer.
NOTE: Do not use the dispenser drawer or door to lift
the washer.
NOTE: If you are installing into a drain pan, you can use
a 24-inch long 2x4 to lever the washer into place.
7. With the washer in its
final position, place
a level on top of the
washer (if the washer
is installed under a
counter, the washer
should not be able to
rock). Adjust the front
leveling legs up or down
to ensure the washer is resting solid. Turn the lock
nuts on each leg up towards the base of the washer
and snug with a wrench.
NOTE: Keep the leg extension at a minimum to prevent
excessive vibration. The farther out the legs are extended,
the more the washer will vibrate.
If the floor is not level or is damaged, you may have
to extend the rear leveling legs.
19