GE GFWN1100 Guide De L'utilisateur Et Instructions D'installation page 6

About the washer control panel.
7
8
9
10
11
12
6
Cycle Signal
Use the Signal pad to change
the volume of the end of cycle signal.
Prewash
(on some models)
Prewash is an extra wash before
the main wash. Use it for heavily soiled
clothes or for clothes with a care label
that recommends prewashing before
washing. Be sure to add high-efficiency
Extra Rinse
Use an extra rinse when additional rinsing
is desired to remove excess dirt and
detergent from soiled loads.
Delay Wash
(on some models)
You can delay the start of a wash cycle
for 10–18 hours, depending on the model.
Press the Delay Wash pad to choose the
number of hours you want to delay
the start of the cycle, then press the Start
pad. The machine will count down and
start automatically at the correct time.
Lock
You can lock the controls to prevent any
selections from being made. Or you can
lock the controls after you have started
a cycle.
Children cannot accidentally start
the washer by touching pads with
this option selected.
My Cycle
(on some models)
To save a favorite cycle, set the desired
settings for wash cycle, soil level, spin speed
and wash temp settings and hold down
the My Cycle pad for 3 seconds. A beep will
sound to indicate the cycle has been saved.
To use your custom cycle, press the
My Cycle pad before washing a load.
To change the saved cycle, set the desired
settings and hold down the My Cycle pad
for 3 seconds.
Press the pad until you reach
the desired volume.
detergent, or the proper wash additive
to the prewash dispenser.
NOTE: When selecting prewash,
it is recommended to use powder
detergent in the main wash (detergent)
compartment.
NOTE: If you forget to fully close the door,
a reminder signal will beep reminding you
to do so.
NOTE: If you open the door when the delay
is counting down, the machine will enter
the pause state. You must close the door
and press Start again in order to restart
the countdown.
To lock the washer controls, press and
hold the Lock pad for 3 seconds.
To unlock the washer controls, press
and hold the Lock pad for 3 seconds.
The control lock icon on the display will
light up when it is on.
NOTE: The Power pad can still be used
when the machine is locked.
NOTE: When using My Cycle, wash
options cannot be modified after the
cycle has been started.
NOTE: If you change wash options with
My Cycle before starting the cycle, the
My Cycle
be returned to the base cycle.