Storage Conditions - Tecno-gaz STERILAIR PRO Manuel De L'utilisateur

ENGLISH
Operation mode
Flow rate
Noise level
Lamps
Wavelength
Ultraviolet energy
UV‐C radiation external emission
Equipment
Reflectors
Lamp duration
Germicidal lamp control
Technical Data of programmer
Daily and weekly programming of 16 switches (8 x ON, 8 x OFF).
With day block programming, there are 56 switch possibilities.
Minimum time resolution between switching points: 1 minute.
Programs are stored on flash internal memory; the clock is powered from the mains
and maintained for a few hours by a special battery.
Ambient temperature: ‐10°C to +55°C (T‐10; T55).
STORAGE CONDITIONS
‐ Temperature
‐ Humidity
‐ Pressure
Before performing installation, make sure the device is intact. Should signs
of damage caused by transportation be detected, do not activate the
appliance and inform the dealer.
‐ 10 ÷ 45 °C
10 ÷ 90 %
500 ÷ 1060 hPa
continuous
3
120 m /h
32 dB
n. 4 UV‐C tubes 25W G13T8 (7 W UVGI)
253,7 nm
2
69 µW/cm at 1 m (per lamp)
none
Dustproof filter; Electronic programmer
Aluminium
9000 hours (1 year: 24 hours x 365 dd)
Anti UV‐C light guide
8