Installing The System; Mounting The Bar Speaker On A Wall - Sony HT-CT290 Mode D'emploi

 VOICE (page 15)
Also used for turning on or off the
Control for HDMI function
(page 18).
 MOVIE/MUSIC (page 14)
Also used for turning on or off the
auto standby function (page 20).
 CLEAR AUDIO+ (page 14)
Also used for entering the Secure
Link mode (page 20).
* The AUDIO,  +, and  buttons have
a tactile dot. Use it as a guide during
operation.
10
US

Installing the system

Basic connections and
preparation
Refer to Startup Guide (separate
document).
Mounting the Bar
Speaker on a wall
You can mount the Bar Speaker on a
wall.
Note
• Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely to two studs in the wall beam.
Install the Bar Speaker horizontally, hung
by screws in studs in a continuous flat
section of the wall.
• Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during the
installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.