Sony HT-CT290 Mode D'emploi page 15

Note
This function is set to off automatically
when you turn off the system.
Using the Clear Voice
function (VOICE)
This function helps make dialogs
clearer.
Press VOICE.
The MOVIE and MUSIC indicators flash
twice.
To turn off this function, press VOICE
again.
The MOVIE indicator flashes twice.
Selecting multiplex
broadcast sound (Dual
Mono)
You can enjoy multiplex broadcast
sound when the system receives a
Dolby Digital multiplex broadcast signal.
Press AUDIO repeatedly.
The channel changes cyclically as
follows.
 
Main Sub Main/Sub
Main
Outputs only the main channel.
The MOVIE and MUSIC indicators flash twice.
Sub
Outputs only the sub channel.
The MOVIE indicator flashes twice.
Main/Sub
Main sound is output from the left speaker
and sub sound is output from the right
speaker.
The MUSIC indicator flashes twice.
Setting Dolby DRC (Dynamic
Range Control)
Useful for enjoying movies at low sound
volume. DRC applies to Dolby Digital
sources.
Hold down AUDIO for 5 seconds to
turn on or off Dolby DRC.
On
Compresses sound in accordance with the
information contained in the content.
The USB and TV indicators flash twice.
Off
Sound is not compressed.
The USB indicator flashes twice.
Setting the Attenuation
function
Distortion may occur when you listen to
a device connected to the HDMI OUT TV
(ARC) or TV IN OPTICAL jack. You can
prevent distortion by attenuating the
input level on the system.
Hold down PLAY MODE for 5 seconds
to turn on or off the attenuation
function.
On
Attenuates the input level. The output level
will decrease at this setting.
The USB and TV indicators flash twice.
Off
Normal input level.
The USB indicator flashes twice.
Tip
Turn off this function if the sound output
from the system is low.
15
US