Remote Control - Sony HT-CT290 Mode D'emploi

Subwoofer wireless sound
No sound is heard from the subwoofer.
 The power indicator on the
subwoofer does not light up.
• Check that the AC power cord
(mains lead) of the subwoofer is
connected properly.
• Press  on the subwoofer to turn
on the power.
 The power indicator on the
subwoofer flashes slowly in green
or lights up in red.
• Move the subwoofer to a location
near the Bar Speaker so that the
power indicator on the subwoofer
lights up in green.
• Follow the steps in "Activating
wireless transmission between
specific units (Secure Link)"
(page 20).
 If the power indicator on the
subwoofer flashes in red, press 
on the subwoofer to turn off the
power and check whether the
ventilation opening of the
subwoofer is blocked or not.
 The subwoofer is designed for
playback of bass sound. When the
input source does not contain much
bass sound, as is the case with most
TV programs, the bass sound may
not be audible.

 Press SW
+ to increase the
subwoofer volume (page 16).
Sound skips or has noise.
 If there is a device nearby that
generates electromagnetic waves
like a wireless LAN or a microwave
oven in use, locate the system apart
from it.
 If there is an obstacle between the
Bar Speaker and the subwoofer,
move or remove it.
 Locate the Bar Speaker and the
subwoofer as close as possible.
 Switch the wireless LAN frequency
of any nearby Wi-Fi router or PC to
5 GHz range.
 Switch the network connection of
the TV or Blu-ray Disc Player from
wireless to wired.

Remote control

The remote control does not function.
 Point the remote control at the
remote control sensor on the Bar
Speaker (page 6).
 Remove any obstacles in the path
between the remote control and the
Bar Speaker.
 Replace both batteries in the
remote control with new ones, if
they are weak.
 Check that you are pressing the
correct button on the remote
control.
The TV remote control does not work.
 Install the Bar Speaker so that it
does not obstruct the remote
control sensor of the TV.
Others
The Control for HDMI function does not
work properly.
 Check the connection with the
system (refer to the supplied
Startup Guide).
 Enable the Control for HDMI
function on the TV. For details, refer
to the operating instructions of your
TV.
 Wait a while, and then try again. If
you unplug the system, it will take a
while before operations can be
made. Wait for 15 seconds or
longer, and then try again.
 Check that the devices connected to
the system support the Control for
HDMI function.
25
US