Sony HT-CT290 Mode D'emploi page 26

 Enable the Control for HDMI
function on the devices connected
to the system. For details, refer to
the operating instructions of your
device.
 The type and number of devices
that can be controlled by the
Control for HDMI function is
restricted by the HDMI CEC standard
as follows:
• Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up
to 3 devices
• Playback devices (Blu-ray Disc
Player, DVD player, etc.): up to
3 devices
• Tuner-related devices: up to
4 devices
• Audio system (receiver/
headphone): up to 1 device (used
by this system)
If all input indicators and sound effect
indicators flash quickly (PROTECT
mode).
 Press  to turn off the system. After
the display turns off, disconnect the
AC power cord (mains lead) then
check that nothing is blocking the
ventilation holes of the Bar Speaker.
All input indicators and sound effect
indicators do not light up.
 The indicators are off. Hold down
BACK for 5 seconds to turn on the
indicators.
26
US
Sensors of the TV do not work properly.
 The Bar Speaker may block some
sensors (such as the brightness
sensor), the remote control receiver
of your TV, or the emitter for 3D
glasses (infrared transmission) of a
3D TV that supports the infrared 3D
glass system or the wireless
communication. Move the Bar
Speaker away from the TV within a
range that allow those parts to
operate properly. For the locations
of the sensors and remote control
receiver, refer to the operating
instructions supplied with the TV.
 does not work.
 The system may be in demo mode.
To cancel demo mode, perform
"Reset" (page 26).
Reset
If the system still does not operate
properly, reset the system as follows.
Be sure to use the touch keys on the Bar
Speaker to perform this operation.
1
Hold down – (volume down) and
 simultaneously for 5 seconds.
All LED indicators flash three times,
then light off.
The settings of the menu and sound
fields, etc. return to their initial
status.
2
Disconnect the AC power cord
(mains lead).
3
Connect the AC power cord (mains
lead), then press  to turn on the
system.
4
Link the system to the subwoofer
(page 20).