Setting Up; Installing The Speaker System - Sony HT-A7000 Mode D'emploi

Setting Up

Installing the Speaker
System
Installing the Bar Speaker
For the installation, refer to Startup
Guide (separate document).
Mounting the Bar Speaker on
a Wall
Bar speaker
Notes
• Prepare screws (not supplied) that are
suitable for the wall material and stability.
Depending on the wall material, the wall
may be damaged.
• Fasten the screws securely in the wall
beam.
• Hang the bar speaker horizontally on the
reinforced wall.
• Have the installation done by a Sony
dealer or licensed contractor and pay
special attention to safety during the
installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall stability,
improper screw installation, natural
disasters, etc.
• Two or more persons are required to hang
the bar speaker for safety.
1
Prepare two screws (not supplied)
that are suitable for the holes on
the wall mounting bracket
(supplied).
More than 30 mm (1 3/16 in)
5.0 mm
(13/64 in)
10 mm
(13/32 in)
2
Measure the depth of the
mounted TV (A) and find out the
required space between the
bottom of the TV and the top of the
bar speaker (B) in the table below.
Space is required to ensure that the
TV does not interfere with the
output surround sound from the bar
speaker towards the ceiling.
(A)
TV
(B)
Bar speaker
Depth of the
mounted TV (A)
Less than 110 mm
(4 3/8 in)
110 mm (4 3/8 in) or
more
4 mm (3/16 in)
Hole on the
wall mounting
bracket
Required space
between the
bottom of the TV
and the top of the
bar speaker (B)
120 mm (4 3/4 in) or
more
200 mm (7 7/8 in) or
more
15
US