Sony HT-A7000 Mode D'emploi page 57

Others
The Control for HDMI function does
not work properly.
 Check the connection with the
speaker system (page 18).
 Enable the Control for HDMI function
on the TV. For details, refer to the
operating instructions of your TV.
 Wait a while, and then try again. If you
unplug the speaker system, it will take
a while before operations can be
made. Wait for 15 seconds or longer,
and then try again.
 Make sure the devices connected to
the speaker system support the
Control for HDMI function.
 Enable the Control for HDMI function
on the devices connected to the
speaker system. For details, refer to
the operating instructions of your
device.
 The type and number of devices that
can be controlled by the Control for
HDMI function are restricted by the
HDMI CEC standard as follows:
– Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up to 3
devices
– Playback devices (Blu-ray Disc
player, DVD player, etc.): up to 3
devices (this speaker system uses
one of them)
– Tuner-related devices: up to 4
devices
– Audio system (receiver/
headphones): up to 1 device (used
by this speaker system)
[PRTCT] flashes in the front panel
display for 5 seconds and the
speaker system is turned off.
 Disconnect the AC power cord (mains
lead) and make sure nothing is
obstructing the ventilation holes of
the speaker system.
[PRTCT], [PUSH], speaker name
([SUB], [RL], or [RR]), and [POWER]
flash alternately in the front panel
display.
 Press  (power) on the corresponding
speaker ([SUB]: optional subwoofer,
[RL]: optional left rear speaker, [RR]:
optional right rear speaker) to turn
each off. For the optional rear
speaker, disconnect the AC power
cord (mains lead), then restart the
speaker system. For the optional
subwoofer, disconnect the AC power
cord (mains lead) and make sure
nothing is obstructing the ventilation
holes of the optional subwoofer, then
restart the speaker system. If they are
reconnected properly, the display in
the front panel display returns to the
normal display.
[HIGH], [TEMP], and [ERROR] appear
alternately for 2 seconds each in the
front panel display, [STANDBY]
appears in the front panel display,
then the speaker system is turned
off.
 High-temperature is detected in the
speaker system. Press  (power) to
restart the speaker system.
[BT TX] appears in the front panel
display.
 Set
[Setup] - [Advanced Settings]
- [Bluetooth Settings] - [Bluetooth
Mode] to [Receiver]. [BT TX] appears
in the front panel display if [Bluetooth
Mode] is set to [Transmitter].
Sensors of the TV do not work
properly.
 The bar speaker may block some
sensors (such as the brightness
sensor), the remote control receiver of
your TV or the emitter for 3D glasses
(infrared transmission) of a 3D TV that
supports the infrared 3D glass system,
or wireless communication. Move the
bar speaker away from the TV within a
range that allow those parts to
57
US