Sony HT-A7000 Mode D'emploi page 52

system far away from the TV/other
wireless devices.
 There is an interference of the
frequency band between the wireless
LAN and the wireless connection of
the optional speakers. Switch the
band of the wireless LAN connection
of the TV or device that is playing an
image to 2.4 GHz.
3D content from the HDMI IN 1/2
jack does not appear on the TV
screen.
 Depending on the TV or video device,
3D content may not appear. Check the
supported HDMI video format. For
details, refer to Help Guide.
High definition video signal (4K/60p
4:4:4, 4:2:2 and 4K/60p 4:2:0 10 bit,
etc.) from the HDMI IN 1/2 jack does
not appear on the TV screen.
 Depending on the TV or the video
device, high definition video signals
such as 4K may not appear. Check the
video capability and settings of your
TV and video device.
 Change the setting of
[Advanced Settings] - [HDMI Settings]
- [HDMI Signal Format] - [HDMI IN 1]/
[HDMI IN 2] according to the video
signal that is supported by a
connected TV or device. For details,
refer to Help Guide.
 When you play high definition video
signals such as 4K video content that
is protected by copyright, connect the
speaker system to the HDMI input jack
that supports HDCP2.2 or HDCP2.3 on
the TV. For details, refer to the
operating instructions of your TV. If
the HDMI input jack that supports
HDCP2.2 or HDCP2.3 on the TV is not
compatible with eARC or ARC,
connect the optical digital output jack
on the TV and the TV IN (OPT) jack on
the speaker system with an optical
digital cable.
52
US
An image is not displayed on the
entire TV screen.
 The aspect ratio on the media is fixed.
Picture and sound of the device that
is connected to the speaker system
are not output from the TV when the
speaker system is not turned on.
 Set
 Turn on the speaker system, and then
 If connected to devices other than
HDR contents cannot be shown in
high-dynamic range.
 Check the settings of the TV and
[Setup] -
 Depending on the [HDMI Signal
Sound
The speaker system cannot connect
to a TV with the BLUETOOTH
function.
 When you connect the speaker
[Setup] - [Advanced Settings]
- [HDMI Settings] - [Control for HDMI]
to [On] on the speaker system, and
then set [Standby Through] to [Auto]
or [On].
switch the input for the device
playing.
those manufactured by Sony that
support the Control for HDMI function,
set [Setup] - [Advanced Settings]
- [HDMI Settings] - [Standby Through]
to [On].
connected device. For details, refer to
the operating instructions of your TV
and the connected device.
Format] setting, an AV device may not
be able to output HDR contents in
HDR format. Change the setting of
[Setup] - [Advanced Settings] -
[HDMI Settings] - [HDMI Signal
Format] - [HDMI IN 1]/[HDMI IN 2]
according to the video format that is
supported by the AV device. For
details, refer to Help Guide.
system and TV with an HDMI cable,
the BLUETOOTH connection is
canceled.