Dometic 10 Série Notice D'utilisation page 34

Troubleshooting
RMD10.5,
RMD10.5T, RMD10.5X,
RMD10.5XT RMD10.5S,
RMD10.5XS
E03
E07
E08
E09
E12
E13
E14
E50
34
Fault
No connection between
power module and display
No cooling capacity in gas
mode
No cooling power in AC
mode
No cooling power in DC
mode
Gas valve check error
Internal communication error Gas operation not possible.
In stand-alone gas mode:
The battery charge of the
battery packs is too low
Gas lock after 3 ignition
attempts
Solution
Contact an authorized customer
service.
Check if the device is at an angle
and adjust it if necessary.
Reset the error.
Contact customer service if this
error occurs again.
Check if the device is at an angle
and adjust it if necessary.
Reset the error.
Contact customer service if this
error occurs again.
Check if the device is at an angle
and adjust it if necessary.
Reset the error.
Contact customer service if this
error occurs again.
Gas operation is not possible.
Reset the error.
Contact customer service if this
error occurs again.
Reset the error.
Contact customer service if this
error occurs again.
Insert new batteries and then reset
the error.
Ignition not possible.
The gas cylinder is empty. Replace
the gas cylinder.
Reset the error.
RMD10
EN