General; Warranty; Safety Instructions - Becker Centronic VarioControl VC420 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
The VC420, as delivered ex works, converts radio signals into control signals
and can be used to control a mainsconnected drive
Structural modifications and incorrect installation which are not in accordance
with these and our other instructions can result in serious injuries, e.g. crushing
of limbs. Therefore, structural modifications should only be carried out with our
prior approval and in accordance with our instructions, particularly the informa-
tion contained in these Assembly and Operating Instructions.
Any further processing of the products which does not comply with their intend-
ed use is not permitted.
The end product manufacturer and fitter have to ensure that all the current stat-
utory, official regulations and, in particular, EMC regulations are adhered to dur-
ing utilisation of our products, especially with regard to end product assembly,
installation and customer advice.
Caution
• Risk of injury by electric shock.
• All electrical installations to a 230 V power network must be per-
formed by an authorised electrician.
• Before assembly, disconnect the power lead from the supply.
• When installing the system, the provisions set down by local public
utilities and the stipulations for wet and damp rooms in accordance
with VDE 100 must be observed.
• For use in dry rooms only.
• Use unmodified Becker original parts only.
• Keep persons away from the systems guide track.
• Keep children away from controls.
• Always comply with relevant national stipulations.
• If the system is controlled by one or more devices, the system guide
track must be visible during operation.
16

General

Warranty

Safety instructions