Section 2. Cleaner Specifications; General Specifications; Section 3. Assembly And Initial Usage; Unpacking - Polaris P91 Manuel Du Propriétaire

Page 6
Section 2. Cleaner
Specifications

2.1 general Specifications

The general specifications for the Polaris P91 are as
follows:
Control unit voltage:
Polaris P91
supply voltage:
Installed load:
Cable length:
Weight of cleaner:
Filtration efficiency:
Cycle length:
The Polaris P91 is a double-insulated product. A
double-insulated electrical appliance is one which has
been designed in such a way that it does not require
a safety connection to ground. The basic requirement
for double-insulation is that no single failure can result
in dangerous voltage becoming exposed so that it
might cause an electric shock and that this is achieved
without relying on an earthed (grounded) metal casing.
This is achieved by having two (2) layers of insulating
material surrounding live parts or by using reinforced
insulation.
Therefore, devices having double-insulated
construction, such as the Polaris P91, do not utilize a
grounded (three-prong) cord/plug.
Section 3. Assembly and initial
Usage

3.1 Unpacking

The packaging should contain the following items
(Refer to Figure 1):
• Polaris P91 robotic cleaner
• Control unit
• Hardware and template
• Owner's Manual
100-240 VAC, 50/60 Hz
30 V DC, max.
70 W max
50 feet
15 m
12 lbs
5.75 kg
fine filtering
2 hours approx
Check that the unit has not been damaged during
transport. If you detect damage, contact Zodiac Pool
Systems, Inc. at 800.822.7933 before using your Polaris
P91 robotic cleaner.
Control Unit
Figure 1. Polaris P91 Components
To unpack the Polaris P91 and its components:
1. Open the top flaps of the carton.
2 Remove the control unit from the carton.
3. Remove the floating cable and then the cleaner
from the carton.
3.2 Attaching the Control Unit to a Wall
1. Place the template, provided with the unit, on
the wall where you want to attach the control
unit.
2. Using the 1/8" drill bit, drill three (3) holes.
Screw the three (3) 1/4" screws, provided with
the unit, into the holes and place the control
unit onto the screws. Refer to Figure 2.
Figure 2. Position Control Unit on the Wall
Cleaner
Floating Cable