Section 2. Cleaner Specifications; General Specifications; S E C T Io N 3 . A Sse M B Ly; Unpacking - Polaris 9350 Sport Manuel Du Propriétaire

Section 2. Cleaner Specifications

2.1

General Specifications

The general specifications for the cleaner are as follows:
C o nt r o l b o x 100-125 VAC, 60 Hz
su p p ly v o lt a ge
S u p p ly v o lt a ge 30 V DC
I nst a lle d lo a d 150 W max
C a b le le ngt h 9 3 5 0 / P 9 3 5 , 9 4 5 0 / P 9 4 5 : 60 ft (18 m)
9 5 5 0 / P 9 5 5 : 70ft (21m)
C le a ne r siz e 16.9 x 18.9 x 10.6 in. (43 x 48 x 27 cm)
( W x D x H )
W e ight o f C le a ne r 21 lbs. (9.5 kg)
P a c k e d w e ight 42 lbs. (19 kg)
All-purpose filter canister
F ilt r a t io n
C y c le le ngt hs Variable programming
The cleaner is a double-insulated product. A double-
insulated electrical appliance is one which has been
designed in such a way that it does not require a safety
connection to ground. The basic requirement for
double-insulation is that no single failure can result
in dangerous voltage becoming exposed so that it
might cause an electric shock and that this is achieved
without relying on an earthed (grounded) metal casing.
This is achieved by having two (2) layers of insulating
material surrounding live parts or by using reinforced
insulation. Therefore, devices having double-insulated
construction, such as this cleaner, do not utilize a
grounded (three-prong) cord/plug.

S e c t io n 3 . A sse m b ly

3 . 1 U np a c k ing
The packaging should contain the following items:
• Polaris cleaner
• Control unit
• Remote Control (9550 Sport/ P955 only)
• Transport and storage caddy assembly components
(Figure 1)
(a) handle frame
(b) support blocks (x 2)
(c) wheels (x 2)
(d) wheel locking clips (x 2)
(e) wheel axle / hubcap (x 2)
(f) base unit
(g) cleaner hook
(h) caddy handle
(i) remote control & attachment hook
x 2
B
A
F
I
F igu r e 1 . T r a nsp o r t C a d d y A sse m b ly C o m p o ne nt s
When unpacking the cleaner and its components:
• Check to make sure each component is in the box.
• Check cleaner and components for damage during
transport.
• If there are any missing parts or damage, contact
®
Zodiac Technical Support at 1-800-822-7933.
3 . 2 A sse m b ling t he T r a nsp o r t C a d d y
1. Unscrew the handnut from the base unit
(Figure 2).
F igu r e 2 . R e m o v e H a nd nu t f r o m
2. Insert the metal handle frame tubing into the
base unit with notch end at the top, then rotate
so the bends are away from you. (Figure 3).
Page 5
D
x 2
C
x 2
x 2
E
H
G
B a se U nit