Section 5. Programming The Cleaner; Displaying Current Day And Time; Changing The Clock Day And Time; Changing Default Cleaning Times - Polaris Sport 9350 Mode D'emploi

Page 14
Section 5. Programming the
Cleaner
(9450 Sport/P945 and 9550 Sport/P955 only)
You can program up to seven preset cleaning cycles to run
from the pool.
NOTE: You cannot change programming or display current
day and time during a cleaning cycle.
5.1

Displaying Current Day and Time

to display current day and time in
24-hour clock format.
Current day and time is displayed for 5 seconds.
5.2

Changing the Clock Day and Time

1. Press and hold
2. Press or
seven (7) days and display desired day.
3. Press to select.
4. Press or
24 hours and display desired hour setting.
for three (3) seconds.
buttons to cycle through
buttons to cycle through
NOTE: Control unit is set to display time in 24-hour
clock format. Time setting will cycle through 1-24.
to select.
6. Press or
minutes setting.
7. Press to select.
8. Press to set time and exit the menu.
9. Press to display current day and time
setting and verify the time you set is correct.
5.3

Changing Default Cleaning Times

Use to change cleaning surface setting.
Default cleaning times are:
Bottom Only: 1 hour 30 minutes
Bottom and Sides:
2 hours 30 minutes
Waterline (9550 Sport/P955):
Variable cleaning time depending on settings
1. Press or
decrease cleaning time in 30-minute increments.
2. Press to select.
buttons to cycle
buttons to increase or