5.2 Changing The Clock Day And Time; Canceling Cleaning Cycles - Polaris 9350 Sport Manuel Du Propriétaire

5 . 4 P r o gr a m m ing C le a ning C y c le s
You can program up to seven cleaning cycles.
Program cleaning for either seven consecutive cycles or
the same cycle repeated over several weeks
(e.g., every Wednesday and Saturday for three weeks).
1. Choose pool cleaning settings to program.
A ll m o d e ls:
Choose
pool or bottom plus sides of pool.
9 5 5 0 S p o r t / P 9 5 5 :
• Choose
addition to bottom or bottom plus sides options.
• Choose
high intensity level cleaning.
• Choose
2. Press to view currrent programmed
cleaning cycles.
Cycle day and time is displayed for three
seconds.
3. When the cleaning cycle you want to change
is displayed, press and hold
seconds.
The days of the week flash twice.
N O T E: If the display flashes all zeros, the time has
not been set (new cleaner). Day and time must be set
before you can program cleaning times, see section

5.2 Changing the Clock Day and Time.

4. Press or
7 days of the week.
5. Press
to select.
Hour setting flashes twice.
6. Press or
through 24 hours.
to select either bottom of
to select waterline only in
to select intensive or
to select pool shape.
for 3 to 5
buttons to cycle through
buttons to cycle
7. Press to select.
Minutes setting flashes zero.
8. Press or
through four 15- minute increments (00, 15, 30,
or 45).
10. Press to select.
The next day to program flashes.
11. Press to program an additional cleaning
cycle for a different day O R
Press to exit the programming menu
Days of the week are lit indicating programs
stored in the control unit memory for that day.
5 . 5 C a nc e ling C le a ning C y c le s
T o C a nc e l a n I nd iv id u a l P r o gr a m :
and hold for 3 to 5 seconds.
1. Press
The days of the week flash twice.
2. Press or
through seven (7) days.
N O T E: If the day of the week flashes with no time
displayed, there is no program set for that day.
Page 15
buttons to cycle
buttons to cycle