Cleaning And Storing The Cleaner; Replacing The Brushes - Polaris 9300 Sport Manuel Du Propriétaire

3
Figure 21. Remove Filter Assembly
Figure 22. Open Filter Assembly
Figure 23. Remove Filter Canister
Figure 24. Wash Filter Canister
7

5.2 Cleaning and Storing the Cleaner

The cleaner must be cleaned regularly using slightly
soapy clean water, do not use solvents such a trichloro-
ethylene or its equivalent. Rinse the cleaner generously
using clean water. Do not let your cleaner dry in direct
sunlight near the pool. The cleaner must be stored on its
own caddy, so that it dries quickly.
1. Place the rear wheels on the caddy side wedges as
shown in Figure 25.
1
Figure 25. Position Cleaner on Caddy
2. Roll the unit into place onto the caddy. Refer to
Figure 26.
NOTE: The cleaner cable must be disconnected from
the control box before removing the cleaner from
the pool. Wrap the cleaner cable around the
hooks located at the rear of the caddy.
Figure 26. Roll Cleaner onto Place on the Caddy

5.3 Replacing the Brushes

The cleaner is fitted with PVC brushes. There are ''wear''
indicators on the brushes. To maintain cleaner perfor-
mance at its best you need to replace the brushes as soon
as one of the wear indicators has been reached (even if
the blade wear is not even). Polaris recommends that
you replace the brushes every two (2) years.
1. Lift the cleaner to a vertical position so that the
handle is up. Refer to Figure 27.
Page 11
2