Cleaning And Maintenance; Cleaning The Filter Canister - Polaris 9300 Sport Manuel Du Propriétaire

Page 10
seconds, when it is powered on, but not submerged
in the water. For pools equipped with a beach area,
this safety feature allows the cleaner to reverse,
and back into the pool when the impeller is out of
the water.
7. Disconnect the power supply cable from the
electrical outlet.
8. Disconnect the cable from the power supply.
9. At the end of each cycle, coil the cable starting
at the cleaner and go toward the connection
point at power supply. Remove coils or twists
along the way.
CAUTION
To prevent damage to the 9300 Sport, be sure to
adhere to the following guidelines:
• Approximately 15 minutes after the cycle is
completed, the light located on the power supply
will flash slowly to indicate that the cleaner may be
removed from the pool. The 15 minute period allows
the motor to cool and will prevent damage to the
cleaner.
• Remove the 9300 Sport from the pool after the
cleaning cycle is completed and store on the caddy.
• Never lift the 9300 Sport out of the pool by the
floating cable. Always use the handle to remove it
from the pool. Refer to Figures 18 and 19.
• Remove the 9300 Sport from pool when super
chlorinating.
Figure 18. Remove Cleaner From Pool
Figure 19. keep Cleaner Vertical to Drain Water
1
2
3
IMPORTANT
• Use your 9300 Sport cleaner as often as needed to
keep your pool clean.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a
permanent basis.
• At the end of each cycle, remove the cleaner from
the pool. Start at the cleaner head and untangle any
coils in the hose before storing the cleaner.
Section 5. Cleaning and Maintenance
WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death, disconnect
(unplug) the cleaner from the power supply before
performing any cleaning and maintenance.

5.1 Cleaning the Filter Canister

The filter canister should be cleaned at the end of each
cycle.
1. Ensure that the power supply cable has been
disconnected from the electrical outlet or that the
floating cable has been disconnected from the
power supply.
2. Remove the cleaner from the water and let the
remaining water drain by maintaining the cleaner
in the vertical position.
3. Set the unit on its wheels.
4. To remove the filter from the cleaner, follow the
steps 1 through 6 (Figures 20 through 23).
5. Push the cover lock (1) and lift the cover (2) until
it is secured in the vertical position. Refer to
Figure 20.
1
2
Figure 20. lift Cleaner Cover
6. Remove the filter assembly from the body (3), as
shown in Figure 21.
7. Push the quick release button on the canister
assembly (4) and pull open the filter assembly (5).
Refer to Figure 22.
8. Separate the filter canister from the filter support
(6), as shown in Figure 23.
9. Wash the filter canister, the filter support, and the
cleaner under water or using a hose (7). Refer to
Figure 24.