Section 5. Cleaning And Maintenance - Polaris P93 Guide Du Propriétaire

Page 10
9.
Remove the cleaner from the pool using the
handle (refer to Figures 21 and 22). Never lift
the cleaner out of the pool by the floating cable.
10. Loosely coil the cable starting at the cleaner and
go toward the connection point at control unit.
Remove any twists along the way. Store the
cable by wrapping it around the hooks located
at the rear of the caddy.
Figure 21. Remove Cleaner From Pool
Figure 22. keep Cleaner Vertical to Drain Water
iMPORTANT
• Use your cleaner as often as needed to keep your
pool clean.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a
permanent basis.
• At the end of each cycle, remove the cleaner from
the pool. Start at the cleaner head and untangle
any coils in the cable before storing the cleaner.
1
2
3
Section 5. Cleaning and
Maintenance
WARNiNg
To avoid electric shock and other hazards which
could result in permanent injury or death, disconnect
(unplug) the cleaner from the power source before
performing any cleaning and maintenance.
5.1 Cleaning the Filter Canister
The filter canister should be cleaned at the end of each
cycle.
1. Ensure that the control unit cable has been
disconnected from the electrical outlet or that
the floating cable has been disconnected from
the control unit.
2. Remove the cleaner from the water and let
the remaining water drain by maintaining the
cleaner in the vertical position.
3. Set the unit on its wheels.
4. To remove the filter from the cleaner, follow the
steps 5 through 8 (Figures 23 through 26).
5. Push the cover lock (1) and lift the cover (2)
until it is secured in the vertical position. Refer
to Figure 23.
1
2
Figure 23. Lift Cleaner Cover