Siemens SITRANS F Mode D'emploi page 45

Appendix
A.1 I/O Connections and Wiring
Terminal Block Wiring - 1010XS2-7
(Refer to manual drawing 1010XS2-7 sheet 3 of 3. When Barriers are used, isolation is
limited to the Barrier's working voltage. Refer to table on manual drawing 1010-341 sheet 3).
These connection diagrams apply to the part numbers listed below.
Table A- 1
FUS1010
①
Table A- 2
Pin#
FUH1010 IP65 NEMA 7 Interface Detector Quick Start
Operating Instructions, 06/2014, A5E02428148-AA
Part Numbers and Connection Diagrams
Menu Lockout Switch S1
FUS1010X Input/Output Wiring (TB1)
Signal
1
2
3 Io1 - Isolated Loop Return
4 Io1 + Isolated Loop Supply
5 ANIN - Analog Input Return
6 ANIN + 4-20mA Input
7 Status - Status Bit Return
8 Status + Status Output
9 PGEN - Pulse Generator Return
10 PGEN + Pulse Generator Output
1010XS2-7 (Sheet 3 of 3) Drawing
7ME3601-ab
where:
a= 1
b= D or F
Function
Not used on Single channel units.
Spannable 4-20mA output proportional to any
available data variable assigned under menu
control.
4-20mA input non-isolated (7ME3531-xF only)
Isolated Status Alarm Emiter
Isolated Status Alarm Collector
Isolated PGEN Emitter
Isolated PGEN Collector
A
Description
43