Publicité
Les langues disponibles
Les langues disponibles
Maintenance and cleaning
WARNING! RISK OF INJURY!
Disconnect the tool from the
compressed-air supply.
CAUTION!
►
Before maintenance, clean off any hazardous
substances that may (due to working pro-
cesses) have accumulated on the tool. Avoid
all skin contact with these substances. If the
skin comes into contact with hazardous dusts,
this can lead to severe dermatitis. If dust is
produced or swirled up during maintenance,
it can be inhaled.
NOTE
►
To ensure correct functioning and long-term
durability of the tool, pay attention to the
following points:
■
Sufficient and continuous oil lubrication is highly
important for optimum functioning.
■
Check the speed and vibration levels after each
use.
■
Check the idle speed regularly and after any
maintenance is performed:
Use a rev counter and perform the measure-
ment without any clamped tools. At a residual
pressure of 6.8 bar, the idle speed may not be
exceeded under any circumstances.
■
If the tool is exhibiting excessive vibration levels,
the cause of the vibrations must be identified
and repaired.
■
Use only the genuine replacement parts
recommended by the manufacturer, otherwise
you could put users at risk. In doubt, contact the
Service Centre.
■
Clean the tool with a soft, dry cloth only.
■
Never use sharp or abrasive cleaning agents
under any circumstances.
PDBS 1800 A1
Troubleshooting
Fault
Possible
cause
Speed too
Motor parts
slow, air
jamming due
escapes from
to dirt.
the outlet.
Pressure
supply too
low.
Tool does
Motor is
not move;
jammed due
compressed
to material
air escapes
build-up.
completely
through the
outlet.
Remedy
Check the
pressure
supply filter
for contamina-
tion.
Check the
pressure sup-
ply filter for
contamination.
Lubricate the
tool as de-
scribed in the
instructions.
If necessary,
repeat the
steps outlined
above.
Lubricate the
tool as de-
scribed in the
instructions.
GB │ IE
│
29
■
Publicité
