Publicité
Anleitung_RG_CT_14_SPK1:_
To switch on your grass trimmer, press the safety
lock-off and the ON/OFF switch (Fig.1/Pos. 2).
To switch off your grass trimmer, let go of the
ON/OFF switch (Fig. 1/Pos. 2).
Do not move the grass trimmer against the grass
until the switch is pressed, i.e. wait until the
trimmer is running.
For the correct cutting action, swing the grass
trimmer to the side as you walk forward, holding it
at an angle of approx. 30° as you do so (see
Figure 19-20).
Make several passes to cut long grass shorter
step by step from the top (see Figure 21).
Make full use of the guide hood in order to avoid
unnecessary line wear.
Keep the grass trimmer away from hard objects
in order to avoid unnecessary line wear.
7. Cleaning, maintenance and ordering
of spare parts
Switch off and unplug the grass trimmer before
putting it away or cleaning it.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Remove deposits from the guard hood with a
brush.
7.2 Replacing the line spool (Fig. 10-12)
IMPORTANT! Make sure that you unplug the
rechargeable battery before replacing the line
spool (Fig. 13+14)!
Attach the knife guard.
Press the sides of the spool cover as shown and
remove it with the spool (Figure 10+11). Ensure
that you do not lose the spring.
Remove the empty line spool.
Thread the ends of the line on the new line spool
through the eyelets in the spool cover (fig. 12)
Fit the spool cover and spool back into the spool
mounting.
Remove the knife guard. Caution: Risk of
30.07.2008
9:58 Uhr
Seite 13
injury.
The line will be cut to the correct length when the
cutting head starts up again.
Caution! Catapulted pieces of nylon line may
cause injury!
7.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Line spool Art.-Nr.: 34.057.20
8. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
9. Faults
The device does not operate: Check whether the
rechargeable battery is charged and whether the
battery charger works. If the device still does not
work even with a voltage supply, please send it
to our customer services department at the
address indicated.
GB
13
Publicité
