Inserting The Drive Battery Into The Vehicle, Connecting The Drive Battery - Reely 2103650 Notice D'emploi

d) Inserting the drive battery into the vehicle, connecting the drive battery
The speed controller does not have a conventional slide switch for switching on/off, but an electronic push
button. Therefore, no preliminary manual switch-off is required when connecting the drive rechargeable
battery to the speed controller.
Caution!
First put the transmitter into operation before connecting the drive battery, see chapters 8. b) and 8. c).
The motorcycle is only suitable for a LiPo drive battery with 2 cells (rated voltage 7.4 V) or a NiMH drive
battery with 6 cells (rated voltage 7.2 V).
Using a drive battery with more cells can result in a fire hazard due to overheating of the speed controller
and overloading the drive of the vehicle and damaging it (such as drive gears, chain). This will void the
warranty!
Check whether the battery has a suitable connector system for the speed controller and that the polarity is
correct (red cable = positive/+, black cable = negative/-).
Press the release button on the left and right of the chassis
(see arrow on the right) so that the lid of the battery holder
can be opened downwards.
Hold the cable with the T-connector sideways and slowly
insert a fully charged drive battery into the battery com-
partment.
Be careful not to damage cables in the battery compart-
ment.
Now connect the drive battery to the speed controller. En-
sure you insert them with the correct polarity. Do not use
force when connecting the rechargeable battery plugs to
the speed controller.
Do not reach into the drive, keep clothing and
body parts or hair away from moving drive parts
(gears, drive chain). Do not hold the rear wheel.
Risk of injury!
Close the lid again so that the two release buttons on the
left and right engage in the chassis. Make sure that the
cable between the battery and the speed controller is not
pinched.
36