Choosing The Installation Spot; Preparing The Unit For Operation - FRIGOGLASS EASYREACH EXPRESS 2.0 Manuel D'utilisation

3.1

Choosing the Installation Spot

The Easyreach Express is a unit that can be used indoors only. Therefore, it should never be placed
outdoors.
Due to the fact that the Easyreach Express is an open type unit, its performance is highly influenced
by the environmental conditions. To minimise the environmental effects on the unit's performance, the
following is recommended:

The unit should not be placed near or inside air streams produced by ventilation fans, open doors
and/or windows

The unit should not be situated under a roof-mounted ventilation system

The unit should have sufficient space to "breathe". Never omit to install the rear spacer to ensure
minimum clearance and allow a minimum clear space of 20cm above the ICM.
3.2

Preparing the Unit for Operation


Always ensure that your unit is installed on levelled floor / counter. There are 4 adjustable feet at
the front and back under the chassis. Please adjust until the ICM levels. Check by using a spirit
level, if available.

Mains connection: If the mains cord supplied is not long enough, do not use an extension lead
and do not change it. A qualified technician should replace the cord with a longer one.

No electric appliances can be used inside the unit.
3.2.2 Levelling the Unit
Place the unit on the chosen spot. Use a spirit level to check whether the unit is levelled on both
directions. The spirit level can be placed on one of the shelves. If not, level the unit by adjusting the
levelling feet placed at the four corners of the base (a 32mm wrench will be needed for this operation).
It is essential that the unit is levelled during operation so as to avoid possible ice formation on the
evaporator's fins due to insufficient drainage of the condensates.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
Do not place the merchandiser:

in direct sunlight or near heat sources (radiators, stoves & other
heating equipment)

outdoors, without proper protection from rain, moisture and other
atmospheric elements

in weather conditions for which it is not certified

in extreme environmental conditions (i.e. extensive exposure to
saline humidity)

on a surface with an angle more than 5
0
ENG
3