Installation - FRIGOGLASS EASYREACH EXPRESS 2.0 Manuel D'utilisation

ENG
3.

Installation

The Easyreach Express packing consists of a wooden pallet, a full body carton box, a plastic bag and
four e.p.s. blocks for the protection of the unit. Unpack the unit and remove it from the pallet.
2
EASYREACH EXPRESS 2.0 [R290] is equipped with HC
refrigerant, and has been tested and proven to be safe according
to related standards.
All necessary actions for safe usage & maintenance of this
appliance are described in this manual and need to be followed
carefully.
This appliance must be installed only by a suitably qualified
person.
Failure to comply with the instructions may result in high-energy
consumption, poor performance of the unit and void warranty.

Keep all ventilation openings in the appliance enclosure or in the
built-in structure clear of obstruction.

Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the
manufacturer.

Do not damage the refrigerant circuit.

Do not use electrical appliances inside the food storage
compartments of the appliance, unless recommended by the
manufacturer.

If the supply cord is damaged, it must be replaced by the
manufacturer, its service provider or similarly qualified persons
in order to avoid a hazard.
After unpacking, check the cabinet for any damage caused during
transportation. In the event of damage, please contact the forwarding
company.
Allow the merchandiser to stand upright for at least 1 hour prior to
connecting to the mains supply. This gives the oil time to run back to the
compressor after transit and installation.