Canon ImageRUNNER C1028i Guide De Démarrage page 49

Power Supply Requirements
220 V to 240 V, 50/60 Hz
Precautions when connecting the power cord
‒
Do not connect this machine to an uninterruptible power source.
‒
Use an AC power outlet exclusively for the machine. Do not use the
other sockets of the AC power outlet.
‒
Do not plug the power plug into the auxiliary outlet on a computer.
‒
Do not use the same AC power outlet for both the machine and any of
the following equipment.
•
Copy machine
•
Air conditioner
•
Shredder
•
Equipment that consumes a large amount of electricity
•
Equipment that generates electrical noise
‒
When unplugging the power cord, keep interval of 10 seconds or more
before plugging it again.
Miscellaneous precautions
‒
The maximum power consumption of the machine is as follows.
imageRUNNER C1028i/C1028iF: Less than 1210 W, 1260 W (with
optional equipment)
‒
Electrical noise or a dramatic drop in mains voltage may cause the
machine or computer to operate incorrectly or lose data.
Installation Requirements
‒
A location with sufficient space
‒
A location with good ventilation
‒
A location with a flat, even surface
‒
A location able to fully support the weight of the machine
Do not install the machine in the following locations, as this may result in
damage to the machine.
‒
A location subject to dramatic changes in temperature or humidity
‒
A location subject to condensation
‒
A poorly ventilated location (If you use the machine for a long time or
to perform a large amount of printing in a poorly ventilated room, the
ozone or other odors generated by the machine may create an
uncomfortable working environment. In addition, chemical particles
are dispersed during printing; therefore, it is important to provide
adequate ventilation.)
‒
A location near equipment that generates magnetic or
electromagnetic waves
‒
A laboratory or location where chemical reactions occur
‒
A location exposed to salt air, corrosive gases, or toxic gases
‒
A location, such as on a carpet or mat, that may warp from the weight
of the machine or where the machine is liable to sink
Installation Space
Required installation space
Maintenance and Inspections
‒
Follow the instructions in the caution label attached to this machine.
‒
Avoid shaking or applying a shock to this machine.
‒
To prevent the paper jam, do not turn the power ON/OFF, open/close
the operation panel or rear cover, and load/unload paper in the middle
of printing operation.
‒
Be sure to remove the toner cartridge from the machine when
transporting the machine.
‒
To avoid exposing the toner cartridge to light, place it in the protective
bag included with this machine or wrap it in a thick cloth.
‒
Do not store toner cartridges in a location subject to high temperature
or humidity or in a location with dramatic changes in temperature or
humidity.
Storage temperature range: 0 to 35 °C (32 to 95 °F)
Storage humidity range: 35 to 85 % RH (no condensation)
‒
Clean this machine regularly. If this machine becomes dusty, it may
operate improperly.
‒
Use a modular cable of 3 m or shorter in length.
‒
Depending on your locale or your telephone connection, you may be
unable to perform data communication. In this case, contact your local
authorized Canon dealer or the Canon help line.
‒
The repairing parts and toner cartridges for the machine will be
available for at least seven (7) years after production of this machine
model has been discontinued.
Legal Notices
Model Names
F151100 (imageRUNNER C1028i)
F151100 (imageRUNNER C1028iF)
WEEE Directive
European Union (and EEA) only.
These symbols indicate that this product is not to be disposed of with
your household waste, according to the WEEE Directive (2002/96/EC), the
Battery Directive (2006/66/EC) and/or your national laws implementing
those Directives.
If a chemical symbol is printed beneath the symbol shown above, in
accordance with the Battery Directive, this indicates that a heavy metal
(Hg = Mercury, Cd = Cadmium, Pb = Lead) is present in this battery or
accumulator at a concentration above an applicable threshold speciied
in the Battery Directive.
This product should be handed over to a designated collection point, e.
g., on an authorized one-for-one basis when you buy a new similar
product or to an authorized collection site for recycling waste electrical
and electronic equipment (EEE) and batteries and accumulators.
Improper handling of this type of waste could have a possible impact on
the environment and human health due to potentially hazardous
substances that are generally associated with EEE.
Your cooperation in the correct disposal of this product will contribute to
the efective usage of natural resources.
For more information about the recycling of this product, please contact
your local city oice, waste authority, approved scheme or your
household waste disposal service or visit
www.canon-europe.com/environment.
(EEA: Norway, Iceland and Liechtenstein)
R & TTE Directive
This equipment (F151100) conforms with the
essential requirements of EC Directive 1999/5/EC
and is usable in EU. (Only for models with facsimile
functionality.)
(For Europe only)
Canon Inc. / Canon Europa N.V
47