RIB MAGIC 105 Mode D'emploi page 24

G
B
M
AGIC 180° INSTALLATION
MAGIC 180° is universal and can be fitted to a left or right hand opening
gate; the procedure is the same as for the 105°, with the following
exception:
- Anchor the box with cement mortar, taking care that none of the mix
finds its way into the enclosure, and checking that the shorter sides
are faultlessly square with the gate when in the SHUT position,
depending on the required opening arc.
The connection between gate and lever can be made as indicated in
figs 9 and 10.
NB - When converting an existing gate with a load bearing support at
ground level, the MAGIC unit can be utilized as a replacement
A
DJUSTMENT OF MAGIC 105° MECHANICAL STOPPER
MAGIC system requires no floor stops or other accessories as the gate
travel limit is determined by means of set screws located internally of the
box. Access to the screws is gained by lifting the cover.
- To adjust the travel limit for the opening movement of the gate, simply
turn the screw (A) left or right as appropriate, then secure the lock nut
to prevent the screw from slipping out of position subsequently (fig. 11).
The procedure is the same for the screw (C) controlling the closing
movement.
support (see installation fig 10).
- Insert the bolts for cover fixing in places cut into the foundation box.
FIG. 9 - TRANSMISSION LEVER
WITH MAXIMUM OPENING ARC OF 155°
A - DO NOT USE
B - Weld to the gate with pivot as shown in Fig. 9.
FIG. 10 - TRANSMISSION LEVER
WITH MAXIMUM OPENING ARC OF 180°
A - Use only when the gate weighs on the motor. N.B. Do not use with
load-bearing hinges.
B - Weld to the gate with pivot as shown in Fig. 10.
9
24
24
10
11