Disposal And Recycling; Troubleshooting - Scheppach bts900 Traduction Des Instructions D'origine

• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
Electrical connection cables must comply with the
applicable VDE and DIN provisions. Only use con-
nection cables with the marking „H05VV-F".
The printing of the type designation on the connec-
tion cable is mandatory.
AC motor:
• The mains voltage must be 220 - 240 V~.
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm .
2
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate

15. Troubleshooting

Problem Possible cause
a)
b)
c)
Motor doesn't start d)
e)
Machine gets slower Too much pressure put on the
during work. workpiece.
Sanding belt comes Belt does not run straight.
off the drive pulleys.
a)
The wood gets burnt
during sanding. b)
ON/OFF switch damaged.
ON/OFF cable damaged.
ON/OFF relay damaged.
Fuse blown.
Motor burnt.
Sanding disc or belt covered
with grease.
Excessive pressure on work-
piece.
www.scheppach.com

14. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be re-
used or recycled. The equipment and its ac-
cessories are made of various types of
material, such as metal and plastic. Defec-
tive components must be disposed of as special
waste. Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing
to the effective use of natural resources. You can
obtain information on collection points for waste
equipment from your municipal administration, pub-
lic waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
Help
a-d) Replace all damaged parts before you use
your machine again.
e) Contact your local service centre. Every at-
tempt to carry out a repair, can be danger-
ous if it is not done by skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
a) Replace disc or belt.
b) Reduce pressure on workpiece.
GB | 25