Toro Recycler 20995 Mode D'emploi page 19

1. 1 to 1-1/2 inches (25 to 38
mm)
2. Self-propel drive bar
3. Cable jacket
2. Hold the self-propel bail 1 to 1-1/2 inches (25 to 38
mm) from the handle (Figure 48).
3. Pull down the cable jacket (toward the mower) until
there is no slack in the cable (Figure 48).
4. Tighten the nut on the cable support.
5. Release the self-propel drive bar and ensure that the
cable is loose.
Note: The cable must be loose with the self-propel
drive bar in the released position; otherwise, the
mower may creep when the bar is disengaged.
Adjusting the Self-propel Drive
Model 20996 only
If your mower does not self-propel properly, adjust the
self-propel drive cable.
1. Loosen the nut on the cable mount (Figure 49).
Figure 48
4. Cable support nut
5. Cable support
1. Cable mount
2. Pull the upper handle back fully rearward.
Note: If the handle does not move smoothly, refer
to Lubricating the Upper Handle.
3. Pull the cable jacket downward until you remove the
slack in the exposed cable (Figure 50).
1. Exposed cable
4. Push the cable jacket upward 1/8 inch (3 mm).
Note: You can place a ruler against the upper side
of the black cable mount and measure how far the
upper end of the cable jacket moves (Figure 51).
19
1
G009696
Figure 49
Figure 50