Publicité
Les langues disponibles
Les langues disponibles
English
7.1.2 Installation of a flanged pump
Installation of pumps with PN6/10
combination flange (flange-end pumps D32 up to DN 65 inclusive)
WARNING! Risk of injury and material damage!
The flange connection can be damaged and develop leaks. There is an injury
hazard/risk of damage by the escape of a hot fluid.
• Never connect two combination flanges to each other!
• The use of securing elements (e.g. spring rings) can leads to leaks at the
flange connection. They are therefore not permissible. The washers supplied
(Fig. 3, item 1) must be inserted between screw heads/nuts and the combi-
nation flange.
• The permissible tightening torques listed in the table below must not be
exceeded, even if screws of higher strength (
splintering can occur at the edges of the long holes. This causes the screws
to lose their preload and the flange connection can become leaky.
• Use screws of sufficient length. The screw thread must protrude at least one
thread turn beyond the nut (Fig. 3, item 2).
DN 32, 40, 50, 65
Screw diameter
Tensile strength class
Permitted tightening torque
Min. screw length for
• DN 32/DN 40
• DN 50/DN 65
DN 80, 100
Screw diameter
Tensile strength class
Permitted tightening torque
Min. screw length for
• 80
• 100
• Install appropriate flat gaskets between pump and counter flanges.
• Tighten the flange bolts across diagonals in two steps to the prescribed tight-
ening torque (see Table 7.1.2).
• Step 1: 0.5 x permissible tightening torque
• Step 2: 1.0 x permissible tightening torque
• Check the flange connections for leaks.
38
Rated pressure PN 6
M12
Ü
4.6
40 Nm
55 mm
60 mm
Rated pressure PN 6
M16
Ü
4.6
95 Nm
65 mm
70 mm
Ü
4.6) are used, since otherwise
Rated pressure PN 10/16
M16
Ü
4.6
95 Nm
60 mm
65 mm
Rated pressure PN 10/16
M16
Ü
4.6
95 Nm
65 mm
70 mm
Salmson 02/2012
Publicité
