Installation Location - Epson BrightLink 475Wi Guide D'installation

Do not use the Touch Unit if you are using or near medical equipment such as a pacemaker.
The magnet within the Touch Unit generates electromagnetic interference which could cause medical equipment
to malfunction.
Do not install the wall mount in a location where the operating temperature for your projector model may
be exceeded. Such an environment may damage the projector.
Install the wall mount in a place free from excessive dust and humidity to prevent the lens or optical
components from becoming dirty.
Do not use excessive force when adjusting the wall mount.
The wall mount may break, resulting in personal injury.
Keep magnetic storage media (for example, magnetic cards or electronic devices such as computers,
digital watches, or cell phones) away from the Touch Unit.
The magnet within the Touch Unit generates electromagnetic interference which could corrupt data or cause the
media or device to malfunction.

Installation Location

•
Before installing the projector, verify the power supply wiring for the installation location.
•
Install the projector away from other electric devices such as fluorescent lights or air conditioners. Some
kinds of fluorescent lights could interfere with the remote control of the projector.
•
Install the projector away from direct sunlight and other bright light sources.
•
It is recommended to keep VGA computer cable length less than 65 ft (20 meters) to reduce external
noise.
•
Install the projector in a location where the projected image is within reach.
•
The projector must be installed in one of the following locations in order for the Touch Unit to function
properly:
•
Mounted on a wall or suspended from the ceiling with images projected from in front of the screen.
•
Mounted vertically on a table with images projected from the front of the table. If using this
installation method, you need the optional interactive table mount (ELPMB29) and attachment plate
(ELPPT05).
•
When powering the Control Pad using batteries, verify that the installation location meets the following
conditions:
•
Install the Control Pad on the same surface as the projection screen. If the projection screen and the
Control Pad installation point are uneven, install the Control Pad approximately 8 in (20 cm) from the
edge of the screen.
•
Make sure there are no obstacles between the Control Pad and the projector (not including the Touch
Unit).
•
Use the optional Remote Control Cable Set (model ELPKC28, part number V12H005C28) to supply power
to the Control Pad in the following situations:
•
The required conditions above are not met.
•
The projection screen and the Control Pad installation point are uneven and the difference in height is
more than 2 inches (5 cm).
•
The projector is placed on a table and projecting to the screen.
•
Multiple projectors are being used.
Warning
Caution
4