Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Press the
button on the remote control, or the [Wide] button on the control panel.
The test pattern is displayed.
Using the Remote Control
A/B
The test pattern contains a guide to help you adjust the displayed image if your screen's aspect ratio is
the same as the projector's native aspect ratio.
C
Change the aspect ratio if necessary
Each time you press the [Aspect] button on the remote control, the aspect name is displayed on the
screen and the aspect ratio changes. You will need to re-display the test pattern after changing the
aspect ratio.
Change the setting according to the signal for the connected equipment.
You may need to project content from a connected device in order to change the aspect ratio.
Remote Control
Alternatively, set the aspect ratio from the Signal menu - Aspect. Following is a list of available aspect
settings:
BrightLink 480i and PowerLite 570/580
•
Auto: Automatically sets the aspect ratio according to the input signal and the Resolution setting
(available only for HDMI image sources).
•
Normal: Displays images using the full projection area and maintains the aspect ratio of the image.
Choose this setting or Auto to automatically resize the image and make the best use of the display
area.
•
4:3: Displays images using the full projection area at 4:3 aspect ratio.
•
16:9: Converts the aspect ratio of the image to 16:9. 4:3 ratio images are elongated horizontally to fit.
Using the Control Panel
Aspect Ratio
Normal
42
Publicité
Table des Matières
