fiac TDRY 6-18 Manuel D'instructions page 50

The control panel illustrated below is the only dryer-operator interface.
Main switch
1
2 Electronic control instrument (DMC15 o DMC14)
The dryer described in this manual basically consists of two separated circuits: a compressed air circuit,
divided into two heat exchangers, and a refrigeration circuit.
The warm and humid entering compressed air goes through an air-to-air exchanger before entering the
evaporator (air-to-refrigerant exchanger) where, due to the contact with the refrigeration circuit, it cools
down to allow the condensation of the humidity it contains. The condensed humidity is then separated and
expelled into the separator.
The cooled air goes through the air-to-air exchanger, where it partially warms up in cooling down the
entering warm air (pre-refrigeration).
The refrigeration circuit needed for these operations is basically composed of a refrigeration compressor, a
condenser and the evaporator, also called air-to-refrigerant exchanger.
5.1 CONTROL PANEL
1
0
sec - min
set
1
TDRY 12-18 Silver - TDRY 49
1
0
set
1
TDRY 63 - 168
I
ON
set
1
5.2 OPERATION
TDRY 6 - 32
DMC 15
ON
2
DMC 14
°C
°F
esc
2
DMC 14
°C
°F
esc
2
Air and refrigerating gas flow diagram
3
K
3
K
3
K
3
GB