fiac TDRY 6-18 Manuel D'instructions page 35

Dear Customer,
thank you for choosing our product. In order to get the best performances out of this product, please read
this manual carefully.
To avoid incorrect operation of the equipment and possible physical risk to the operator, please read and
strictly follow the instructions contained in this manual. Note, these instructions are in addition to the safety
rules that apply in the country where the dryer is installed.
Before packing for shipment each TDRY series refrigerated air dryer undergoes a rigorous test to ensure
the absence of any manufacturing faults and to demonstrate that the device can perform all the functions
for which it has been designed.
Once the dryer has been properly installed according to the instructions in this manual, it will be ready for
use without any further adjustment. The operation is fully automatic, and the maintenance is limited to few
controls and some cleaning operations, as detailed in the following chapters.
This manual must be maintained available in any moment for future references and it has to be
intended as inherent part of the relevant dryer.
Due to the continuous technical evolution, we reserve the right to introduce any necessary change without
giving previous notice.
Should you experience any trouble, or for further information, please do not hesitate to contact us.
The product identification plate,
on the back of the dryer, shows
all the primary data of the
machine. Upon installation, fill in
the table copying the data
shown on the identification
plate. These data must always
be referred to the manufacturer
or to the dealer
information or spares
needed, even during
warranty period.
The removal or the alteration of
the identification plate will void
the warranty rights.
For 12 months from the installation date, but no longer than 14 months from the delivery date, the warranty
covers eventual faulty parts, which will be repaired or replaced free of charge, except the travel, hotel and
restaurant expenses of our engineer.
The warranty doesn't cover any responsibility for direct or indirect damages to persons, animals or
equipment caused by improper usage or maintenance, and it's limited to manufacturing faults only.
The right to warranty repairs is subordinated to the strict compliance with the installation, use and
maintenance instructions contained in this manual.
The warranty will be immediately voided in case of even small changes or alterations to the dryer. To
require repairs during the warranty period, the data reported on the identification plate must be notified.
IDENTIFICATION PLATE
Nominal Flow Rate
when
Max Inlet Air Temp.
are
the
Refrigerant (Type and qty)
Refrig. Design Pres. HP/LP
Electric Nominal Power
WARRANTY CONDITIONS
Model
Serial No.
Code
Max Air Pressure
Ambient Temp.
Electric Supply
Fuse Max.
Manufactured
Model
Serial No.
Code
Nominal Flow Rate
Max Air Pressure
Max Inlet Air Temp.
Ambient Temp.
Refrigerant
Refrig. Design Pres.
HP/LP
Electric Supply
Electric Nominal Power
Fuse Max.
Manufactured
GB
Nl/min
barg
°C
°C
type/kg
barg
ph/V/Hz
W/A
A