Sound-Control Operation; Display; Use As Stand-Alone Device Or Master Device; Slave Mode - Renkforce DL-LED162 Notice D'emploi

b) Auto running mode
• Select automatic mode again (display AU01-AU30) with the button MODE.
• Select the desired automatic programme (AU01-AU30) with the UP and DOWN buttons.
• Push the ENTER button.
• Use the buttons UP or DOWN to select the desired speed for the programme run (display SP01-SP99).
c) Sound-control operation
• Select automatic mode again (display Sound-control-operation - So01-So30) with the button MODE.
• Select the desired sound-control programme (So01-So30) with the buttons UP or DOWN.
A microphone for music control is installed in the device. The rotary control Sound Sensitivity on the rear
of the device can be used to set music sensitivity.
d) Display
This setting switches the display on and off or turns the display.
• Push the MODE button until the display LED lights up in the display.
• Set the display alignment with the buttons UP and DOWN.
• Push the button ENTER while the display LED is still lit.
• Use the buttons UP or DOWN to select the desired setting Leon or LeoF.
If there is no longer any input through the buttons, the device returns to MODE AUTO.
e) Use as stand-alone device or master device
• Switch to automatic operation (display AU01-AU30) or sound-control operation (display So01-So30).
• Select the desired option of the selected operating mode.
If the device is in automatic or sound-control operation, it is automatically set as stand-alone or
master unit.
The first unit is defined as the master unit. All other series-connected DL-LED162 act as slave
units.
f) Slave mode
• Switch to the MODE for address setting (display A001-A512).
• Push the button ENTER twice until the display shows SL 1 or SL 2.
• Use the buttons UP or DOWN to select the setting SL 1 or SL 2.
29