Placing The Dishwasher - Inventum VVW5520 Mode D'emploi

7

placing the dishwasher

Position the appliance in the desired location. Make sure the location is solid and flat. The dishwasher is equipped with water
supply and drain hoses that can be positioned either to the right or the left sides to facilitate proper installation.
ELECTRICAL CONNECTION
Ensure the voltage and frequency of the power corresponds to those on the rating label. Only insert the plug into an
electrical socket which is earthed properly. Use the required fuse 16 amp.
COLD WATER CONNECTION
Connect the cold water supply hose to a threaded 3/4 (inch) connector and make sure that it is
fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water run to
make sure that the water is clear. This precaution is needed to avoid the risk of the water inlet to be
blocked and damage the appliance.
Attention: the dishwasher can not be connected to a warm water supply.
DRAIN HOSE CONNECTION
Insert the drain hose into a drain pipe with a minimum diameter of 40 mm, or let it run into the sink, making sure to avoid
bending or crimping it. The top of the hose must be less than 600 mm.
please hang up the drain hose either way A or B
Note: the top of the
hose must be less
than 600 mm.
front
drain pipe
A
B
Ø 40 mm
Counter
English •
37