Setting The Dishwasher - Inventum VVW5520 Mode D'emploi

5

setting the dishwasher

SWITCHING THE DISHWASHER ON AND OFF
1
• Switch the dishwasher on by pressing the On/off button (1).
• Select the desired program by pressing the corresponding program button P (2).
• Press the Start/Pause-knop (3) to start the program. The indicator light of the selected program will blink.
When the machine has finished a buzzer will sound for 8 seconds. The indicator light of the used program stops blinking.
• Switch the dishwasher off with the On/off button (1).
NOTE!
You can slightly open the door and wait a few minutes before unloading the dishwasher. The dishes and
cutlery will still be very hot and may break as a result of the heat. Moreover, the dishes dry better when allowed
to stand for a few minutes.
CHANGING OR PAUSING A PROGRAM
If you would like to change a program while a washing cycle is already running.
• Press during 3 seconds the Start/Pause button (3). Select another program and switch the dishwasher on again.
TIP: forgot to add a dish?
1. Press the Start/Pause-button (3) to pause the program.
2. Carefully open the door a little.
3. Wait until the spray arm stops turning and than open the door completely.
4. Place the forgotten dishes in the dishwasher.
5. Close the door.
6. Press the Start/Pause-button (3) to restart the program. The program will resume after 10 seconds.
34
• English
2
3