Rizzoli RE - RVE Série Manuel D'utilisation page 87

2.16 WOODBOX EXTRACTION
To remove the woodbox it is necessary to extract
the woodbox to limit switch, remove the two
thumbscrews that keep it fixed to the sliding rails.
When the box is free, it can be lifted and extract­
Picture 20 – Woodbox extraction.
2.17 STANDARD PLINTH REGULATION
The regulation of the plinth must be done inside
the woodbox, to access the vain extract the wood­
box as described in paragraph 2.16.
The plinth of the cookers can be regulated in order
to match the space in which the cooker is insert­
ed. It is possible to adjust the level of the cook­
er by operating on the levelling pins that can be
0­60
0­60
mm
mm
N. 24
N. 24
Picture 21 – Regulation of the height of the cooker with hex key through the levelling pins.
ed. To reinsert the woodbox repeat the operations
in the opposite sense paying attention to insert
correctly the woodbox in the sliding rails.
regulated in height. To do this, it is necessary to
remove the woodbox and regulate singularly each
pin placed in the plinth near the corners, so that
the adjustment of the cooker is correct.
For the regulation of the pins, use an hex key n.24
(see picture 21). The pins have an excur sion of 60
mm.
85