Rizzoli RE - RVE Série Manuel D'utilisation page 80

RE - RVE range with oven
Picture 9 - Multiflue cooker with oven, predisposition of the correct flue outlet.
2.11 CORRECT CONJUNCTION TO THE CHIMNEY
If the conduct of the chimney starts from a lower
floor than the connection point of the cooker, it
may be necessary to close the conduct under the
connection pipe with fireproof materials. If you
have the chimney behind or up, you have to use
the connector with bayonet coupling. This must be
Picture 10 - Tolerance for flue outlet on the top and back. The tolerance depends on the orientation of the
connector.
If you have a lateral chimney in correspondence
of a side, the connector is sliding. To install it cor­
rectly, it is necessary to remove the cooking plate.
Now, the connector must be completely inserted
inside the wood fired cooker or the chimney, keep­
ing the fixing buttonhole on the same side of the
inserted and turned so that it can remain blocked.
This connector has a tolerance of about 1 cm to
make the installation easier. The tolerance is avail­
able according to a single direction which depends
on the orientation of the connector (see picture
10).
Y
+/-
10 mm
cooker. Then, you can place the wood fired cooker,
extract correctly the connector so that it connect
the cooker with the chimney. Finally, bend the but­
tonhole and block the parts with the screw-lock
(see picture 11).
78
X
+/-
10 mm