Display; Time And Date; Language; Airplane Mode - Nutricia flocare Infinity III Mode D'emploi

7.4.6

Display

The DISPLAY BRIGHTNESS can be set to a convenient level depending on the ambient conditions. Nutricia
recommends to set the DISPLAY BRIGHTNESS to maximal when used in bright sunlight as to ensure full visibility.
This display illumination can be set to AUTO DIMMING mode when connected to the mains.
When AUTO DIMMING is set to ON, the display will be dimmed after 2 min.
When AUTO DIMMING is set to OFF, the display will always be illuminated.
Note: When the pump is running on battery power only, the display will always be dimmed after 2 min. in order
to extend battery life.
7.4.7

Time and date

The Flocare Infinity III uses real time and dates in reporting the administered volumes in 30-day HISTORY as well
as in the THERAPY DETAILS screens. To ensure accuracy of data, the actual time and date according to your
local time zone must be set.
Set the time and date by pressing the SETTINGS
local time zone.
Note: Daylight savings are not automatically performed.
7.4.8

Language

Set the language by pressing the SETTINGS
language.
Note: at first pump start up or after a factory reset, the Infinity will guide you automatically through the language
selection.
7.4.9

Airplane mode

Not in first release
7.4.10

About this pump

Information concerning the pump is gathered in the ABOUT THIS PUMP screen where you can check:
Serial number, Manufacturing date, last maintenance check date, PCB hardware revision, Software version,
current Time and date settings and data communication mode.
Note: a Nutricia help desk employee might ask for this information for support reasons.
7.5

PROGRAMMING THE PUMP

Caution: Before programming the pump, always be convinced that your selected therapy and its parameters are
correct. In case of any doubts, consult your care giver.
Therapies are programmed via the THERAPY [
The Flocare Infinity III supports the following therapies:
Volume – Rate
Administering of a programmed VOLUME (mL) with a programmed RATE (mL/h).
Rate Administering with a programmed RATE (mL/h) but wit hout a programmed VOLUME (mL)
Intermittent
Administering of a programmed VOLUME (mL) divided over different portions with a
programmed RATE (mL/h) with programmed PAUSE (interval) times.
IMPORTANT:
Therapies RATE and INTERMITTENT are disabled by default, if a desired therapy does not appear when the
THERAPY button is pressed, you can enable them by selecting: SETTINGS " DEFINE THERAPY LIST
See chapter
7.4.1 'Define therapy list'
button, navigate to TIME AND DATE and set these to your
button, n avigate to LANGUAGE and select your preferred
] button.
for more information.
- 14 -