Haverland ES4 Mode D'emploi page 16

STEPS TO FOLLOW:
EN
1） When the appliance is mounted on the wall, the minimum distances given in Figure 2 must be respected.
2) USE THE PATTERN INCLUDED WITH THE INDICATED INSTRUCTIONS.
Place the pattern on the floor against the wall (Figure 3).
3) Mark the four upper drill holes for securing. Drill four 6-mm diameter holes x 32-mm deep. Insert the plugs and secure the two upper
brackets with the screws.
4) Screw the lower metal bracket to one of the central channels at the base of the emitter (Figure 4). Hang the appliance on the upper
brackets and ensure that it is horizontal. Screw the lower metal bracket to the walls.
Model
Power
Value of A
Figure 4
5) Before plugging the appliance into a mains socket, verify that the actual mains voltage corresponds to the value given on the appliance
ratings plate and that and that the available current is adequate for the required power.
Note: If the pattern is lost, the steps described below can be followed. When the radiator position has been decided, the positions have to
be marked as follows. Apply two pieces of adhesive tape to the wall as shown below, then follow Figure 5 to mark the four drill holes.
E S 4 E S 6
500 W 750 W
181 333
E S 8 E S 1 0
1000 W 1250 W
484 636
Figure 5
14
Figure 2
E S 1 2
1500 W
788
Figure 3