Changing Autoreduction Settings For Incoming Faxes; To Change Autoreduction For Incoming Faxes - HP LaserJet 3015 Mode D'emploi

Changing autoreduction settings for incoming faxes

If the fit-to-page option is turned on, the device automatically reduces long faxes up to 75
percent to fit the information on the default paper size (for example, the fax is reduced from
legal to letter size).
If the fit-to-page option is turned off, long faxes print at full size on multiple pages. The
factory-set default for incoming fax autoreduction is On.
If you have the stamp-received faxes option turned on, you might also want to turn on
autoreduction. This reduces the size of the incoming faxes slightly, and prevents the page-
stamp from forcing a fax onto two pages.
Make sure that the paper-size setting matches the size of the paper that is loaded in the
Note
media input tray. To change the default paper size, see the electronic User Guide.

To change autoreduction for incoming faxes

1. Press
2. Use the
3. Use the
4. Use the
5. Use the
44 Chapter 2 Faxing (basic)
/ .
MENU ENTER
< or the > button to select Fax setup, and then press
< or the > button to select Fax Recv. setup, and then press
< or the > button to select Fit to page, and then press
< or the > button to select On or Off, and then press
selection.
/ .
MENU ENTER
/ .
MENU ENTER
/ .
MENU ENTER
/ to save your
MENU ENTER
ENWW