Shelf Installation Instructions - FRIGOGLASS ICOOL 40/150 Manuel D'utilisation

b. Always ensure that your merchandiser is installed on a stable surface/floor and is properly
levelled. There are 2 adjustable feet for all models at the front under the chassis apart from
ICOOL-1300 HD which has 3 adjustable feet. The level foot at the middle of the cooler must be
adjusted in such a way that the lower edges of the internal cabin are aligned. The below given
check points must be on the same line.
There are 2 additional adjustable feet for ICOOL-40 & 150 models at the back under the chassis.
Please, adjust until the ICM levels and check using a spirit level, if available. Take necessary
precautions if lifting is needed during installation. Keep unauthorised people away from the cooler until
installation is completed.
c. The merchandiser must stand upright for at least 1 hour after transportation and prior to start-up.
This gives the oil time to run back to the compressor after transit and installation.
d. Allow a minimum gap of 100mm at the back. To make that possible, please turn the back spacer
as shown below.
e. Do not place anything on top of the cooler.
Note: Relocation of the ICM inside the outlet
a. Empty the ICM and unplug from mains supply.
b. Fully extract the levelling feet.
c. Move the unit to the desired location with the assistance of another person.
3.2

Shelf installation instructions

To adjust the shelf first unload it, lift it and unclip the shelf clips (4). Place the clips in the desired
position and reposition the shelf. Make sure that the horizontal metal rods at the bottom of the shelf
are between the front and back shelf clips, as shown below.
Check
points
Level foot at
the middle
Rotate back
spacer
ENG
11